Would you mind if we ask TLV9002? There is the description "Open-loop output impedance=1200ohm" on the datasheet. We would like to know output impedance in case of ...

Using SDK 10.0.0.35 with ccs 12.8.0.00012 and TMDSCNCD263P trying to run enet_cpsw_socket_am263px-cc_r5fss0-0_freertos_ti-arm-clang. Created a very simple network like the example suggests ...

I'm going to use AWR1642EVM with DCA1000 to get the MIMO raw data, and generate a virtual antenna array. (as figure 5) (FIGURE BELOW IS FROM TI DOCUMENT.) I know that there are two TX and four RX on ...

I have a problem with the DAC output: it always stays at 0 volts. To provide some context, I designed and prototyped two bipolar voltage sources using the DAC8812 and two OPA2277 (based on the bipolar ...

For our project, we would like to run our program with the CPU at 32kHz, corresponding to RUN1 or RUN2 modes. However, when we call the function DL_SYSCTL_switchMCLKfromSYSOSCtoLFCLK(false), the ...

I am trying to initialize the timer and PWM.First issue is the timer interrupt -is being called but I see there is a timing issue. Here is my calculation for 1 second timer: To clarify, if you set a ...

As stated in the safety manual, the junction temperature could be measured on ADCB. But the controller has only ADCA and ADCC so is there another way to measure the temperature of the device?

The TI YouTube series "Teaching Old Motors New Tricks" is a great source for information. Some even call it the bible of motor control. Sorry, this is not available ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

I am working with the AM62x-LP evaluation board and have encountered some confusion regarding the flash memory interfaces supported and the configuration observed in U-Boot. 1. Memory Interface ...

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

My project using TDA4 VH + SDK 8.6 before. Secure boot is normal. Now I want to using SDK9.1.The chip has already burned the keywriter. Because sdk8.6 and sdk9.1 use the same keywriter version, So we ...