Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

For our project, we would like to run our program with the CPU at 32kHz, corresponding to RUN1 or RUN2 modes. However, when we call the function DL_SYSCTL_switchMCLKfromSYSOSCtoLFCLK(false), the ...

As stated in the safety manual, the junction temperature could be measured on ADCB. But the controller has only ADCA and ADCC so is there another way to measure the temperature of the device?

The TI YouTube series "Teaching Old Motors New Tricks" is a great source for information. Some even call it the bible of motor control. Sorry, this is not available ...

The following is a waveform of a EEG signal collected by me, which has been filtered and displayed in five frequency bands including alpha, beta, etc. I have the following questions about these: ...

I am trying to enable JTAG debugging for beagle bone black with FTDI based JTAG debugger. I got reference to the TI suggested debuggers from the below TI link. https ...

I use CCS Theia 1.3.1 and want to save user data from start address 0x3c00, the data size is small and only need to be written a few times, so it isn't necessary to use the eeprom way, so I uncheck ...

I am using a awr1642boost eval board . My main task is to get RAW data of UART from Eval board and filter that data to get range and distance of a object in front of it . After getting the RAW data ...

When I was configuring cascading, when I reached the channel configuration step, an error message was displayed as shown in the figure below, and its related meaning ...

I appreciate your attention to my question. Here’s what I’m trying to do: Ultimately, I want the PC program to load the built DSP image into RAM, boot it, and run it. But before that, I need to verify ...

I have a problem with XDS560 v2 Blackhawk JTAG emulator (TMDSEMU560V2STM-EU). When I trying to Test Connection from CCS Target Configuration window I get these errors: [Start: Blackhawk XDS560v2-USB ...

When I'm trying to load the program in flash memory of TMS320F28377D processor, I will get the following problem: C28xx_CPU1: File Loader: Data verification failed at address 0x0008222C Please verify ...